Manual Build and Install Instructions for Asus Eeepc

Step 1: Installation Prerequisite Steps

Warning

This process is experimental and not fully tested.

View the current Release Notes for additional information on this release.

Note

You will need root access to complete many of the steps while installing HPLIP. If you do not have root access contact your system admin for assistance.


Step 2: Install Dependency Packages

A. Open a terminal shell.

B. Add/Update your apt repositories.

Add the xandros/debian repositories as per the guide below:

EeeUser Repositories Guide

Enter this command:

sudo apt-get update

C. Install the required dependency packages.

Enter this command: (choose the appropriate command depending on your version)

sudo apt-get install gcc g++ libc6 make python-dev libcupsys2-dev cupsys-bsd libusb-dev libtool libjpeg62-dev libssl-dev libsnmp9-dev python-reportlab libsane-dev libsane

Step 3: Download HPLIP

Note

We recommend that you download the HPLIP tarball to your home or desktop directory.

A. Click here to Download the Regular Tarball

B. Go to the directory where you downloaded the HPLIP tarball.

Example:

cd ~/Desktop

C. Uncompress the tarball.

Enter this command:

tar xvfz hplip-3.12.6.tar.gz

This will create a directory with the same name as the tarball file.

D. Change your working directory to the hplip-3.12.6 directory.

Example:

cd hplip-3.12.6

Step 4: Configure HPLIP for installation

A. This step configures the development environment and checks that your system is ready to install HPLIP.

For specific information on using ./configure and the different options please go here. Also reference your distro documentation and configuration for additional information on which tags are relevant.

Enter this command (select the appropriate command depending on your system configuration):

32 bit distro users (most users will use this command):

./configure --prefix=/usr --enable-qt4 --disable-libusb01_build --enable-doc-build --enable-cups-ppd-install --disable-foomatic-drv-install --disable-foomatic-ppd-install --disable-hpijs-install --disable-udev_sysfs_rules --disable-policykit --disable-cups-drv-install --enable-hpcups-install --enable-network-build --enable-dbus-build --enable-scan-build --enable-fax-build

64 bit distro users:

./configure --libdir=/usr/lib64 --prefix=/usr --enable-qt4 --disable-libusb01_build --enable-doc-build --enable-cups-ppd-install --disable-foomatic-drv-install --disable-foomatic-ppd-install --disable-hpijs-install --disable-udev_sysfs_rules --disable-policykit --disable-cups-drv-install --enable-hpcups-install --enable-network-build --enable-dbus-build --enable-scan-build --enable-fax-build

Step 5: Run Make

A. This step will compile the HPLIP source.

Important

You want to run make as a regular user, NOT as root.

Enter this command:

make

Step 6: Run Make Install

A. Run the symlink fix script.

sudo python ./installer/fix_symlink.py

Or to run the script manually run:

cat /installer/fix_symlink.py

B. This step will install HPLIP.

Enter this command:

sudo make install

Step 7: Post Installation Step(s)

A. If you are going to be setting up a printer with USB and the printer is already plugged in, you will need to do one of the following:

  1. Unlpug and re-plug in the USB printer, or
  2. Restart your PC.

Failure to do this will cause your USB printer to not be detected by HPLIP.


Step 8: Configuring your printer using hp-setup

Continue to hp-setup